Butterfly Valve with Counterweight

  • (1 đánh giá)
  • Nhà sản xuất: Sapag

Nơi sản xuất: Pháp

Giá: Gọi liên hệ

Lượt xem: 28

Đặt mua ngay

The safety butterfly valve used generally in order to protect a pump or a turbine and permits an opening and/or a closing according with the process. The counterweight actuator consists of a weight fixed to an arm, which is mounted on the shaft of the valve. The opening and the upholding in opening make by a hydraulic jack. The weight closes the valve when the pressure of the jack is out.

Tư vấn và hỗ kỹ thuật

Bảo hành ít nhất 12 tháng theo tiêu chuẩn NSX

Hotline

0988 737 147

Liên hệ báo giá

Đánh giá của bạn về sản phẩm này:

Sản phẩm cùng danh mục

Tài liệu tham khảo

Thông tin sản phẩm

The hydraulic power pack and the electrical cubicle are fixed on the same frame. To operate many valves is possible with the same equipment: in this case each valve has got an independent circuit, but with a common pressure supply.

The valve is holded in opening with the hydraulic pressure, it is necessary to compensate the internal hydraulic leakages, risponsable of a falling pressure and then a, not desirable, progressive closing of the valve. Two different technologies can make this « leakage control cycle » (Automatic cycle) :

a) Technology with limit switch : When the « leakage control » switch, located few degrees before the « opening » limit switch, switches on, the hydraulic pump starts. This technology is supplied in standard.
b) Technology with accumulator. A « low pressure » pressure gauge starts the hydraulic pump in order to blow up the accumulator.

Scroll