In order to use your actuator in any application, the KTA3/4 and TTA3/4 interfaces allow you to obtain a 3/4-inch drive square that can accommodate any socket and thus operate various forms of drive.

The KTA models are designed for actuators equipped with a straight or angled head and can be directly mounted on the hollow head.

We also offer a complete range of sockets suitable for the most common square outputs.

The KTA and TTA interfaces enable the actuators to drive the FSB and CSB adaptors, plus the extenstion bars.

KTA models are only intended for actuators fitted with a straight head or right angle head.

The TTA models fix directly on to the banjo head. They also attach to the FUA adaptator if you want to use it with an extension bar.

The KHA002 interface allows the handling of EB0xx extension bars (telescopic valve keys) with a banjo head.
Please note that this configuration is not compatible with handwheels with a rising stem.

We have a wide range of extension bars which enable operators to move away from the handwheel or valve, notably in the case of tapered handwheels and underground / buried valves.

Light and robust, they can be used on rising stems up to a 48 mm maximum diameters.

The EBX02 extension bars fix directly on to the CSB adaptors. The EBX04 extension bars fix on to the FUA adaptors using the TTA interface, or directly onto the FSB.

All the extension bars can connect to our actuators using the TTA interface for the banjo heads and the KTA interface for straight and right angle heads.

The EB00X telescopic extension bars are specifically adapted for manipulating underground / buried valves. On one end they have a square ¾” male connector that connects to a standard socket. They can be activated either by a straight or right angle actuator, or by an actuator with a banjo head (using the KHA002 interface, see below).

In case the valve is deep in the ground, one can use the EB01X extensions to the telescopic EB00X.

These protectors, integrated into the self-adjusting and self-centering fingers adaptors (SAxxx), are designed to protect the handwheel from being scratched during use.

They can be built into the adaptor during assembly in the factory or added later without difficulty. They are made from high performance polyethylene, which is anti-static and resists wear and tear.

Il existe une interface pour chaque adaptateur :

• SA103 pour l’adaptateur SA003
• SA104 pour l’adaptateur SA004
• SA105 pour l’adaptateur SA005
• SA106 pour l’adaptateur SA006
• SA107 pour  l’adaptateur SA007

The KPA interface enables the handling of adaptors SAxxx and SUAxxx without a hollow head. Please note, this configuration is not compatible with rising-stem handwheels.